Pricer Pro 

Price history for
E3D All-metal v6 HotEnd Full Kit - 1.75mm Universal - Direct, 12v - Approximately 120mm PTFE (ASSEMBLY REQUIRED)

E3D All-metal v6 HotEnd Full Kit - 1.75mm Universal - Direct, 12v - Approximately 120mm PTFE (ASSEMBLY REQUIRED)
Buy on Amazon
$63.35
(as of 2018-12-16 12:51 UTC - Details)
  • Heater Cartridge - 12V 30W
  • Thermistor Cartridge
  • 30x30x10 DC Fan
  • Fan Duct - Cable Tie
  • 100mm PTFE/800mm PTFE (Depending on bowden add-on or not)
E3D All-metal v6 HotEnd Full Kit - 1.75mm Universal - Direct, 12v - Approximately 120mm PTFE (ASSEMBLY REQUIRED)
Buy on Amazon
$63.35
(as of 2018-12-16 12:51 +00:00 - Details)

  • Heater Cartridge - 12V 30W
  • Thermistor Cartridge
  • 30x30x10 DC Fan
  • Fan Duct - Cable Tie
  • 100mm PTFE/800mm PTFE (Depending on bowden add-on or not)



Amazon Price Track

Get notified when this item's price drops. (You can unsubscribe at any time.)

Email me when the price drops.




Should I Buy This Now?

How long can you wait? Two days? Buy now. Two months? Track the price and see what happens.




Description

The v6 HotEnd Full Kit from E3D has been redesigned for your convenience from the ground up! This new hot end contains the same signature high temperature performance for high-temp printing, as well as increased functionality for printing soft and flexible filaments. The v6 HotEnd allows you to print a wide variety of materials, from soft and flexible to sturdy and strong. This is possible due to the PTFE (Polytetrafluoroethylene) liner tube through the hotend that you can extend into your extruder - this gives the ability to add the confinement and constraint needed to make excellent quality prints with flexible filaments. This technology opens new doors for your 3D printing aspirations. With High Temperature Performance, you can print with high-temp materials like Polycarbonate and Nylon - this also eliminates HotEnd meltdown failures that are common with PTFE designs. Even though the v6 has a PTFE liner inside the hotend the liner is never subjected to high temperatures so there is no risk of damaging the liner through overheating. Basically, this design is really in-tune with all the elements, so your prints will come out crisp and accurate. The v6 has cut back on a bunch of bulk. This clean-cut version's overall length is only 62mm, and there are significant reductions in the X/Y dimensions by using the new injection moulded fan duct. Are you eager to start printing right away? Good. So are we - and that's why here at MatterHackers we praise the v6 HotEnd. No adhesives, Kapton tape, or soldering is needed to get started. The new v6 simply locks into place with a little screw, high-temp glass sleeving is used to insulate the thermistor legs. This makes installing the hotend (as well as removing) a quick and smooth process compared to earlier methods involving various adhesives.The parts of the hotend just screw together, and the fan duct naturally clips in - this can be manipulated in different ways to suit your setup preference.


3D Printer Extruders Top Sellers




Countries
CanadaUnited KingdomUnited States